|
|
Series
GX92, tip angle 92°. Ready-to-use. |
|
Solid
tungsten carbide engraving cutter, halfened, V-shaped 92°,
ready-to-use ground with or without front width b.
Halfening flat and cone shape (cutting edge)
polished.
Special engraver used to slot material such as
acrylic, alucobond / dibond to bend it after that
operation. Typically used to form hoods, cases,
boxes, facade elements or similar.
Technique: Sheet is to be slottet completely (or
almost cmpletely) to the bottom, see sketch (1).
After that the material can be easily bent (2).
Perhaps you want to add some glue to fix the
construction.
Our "box bits" are ground 92° tip angle,
normally with additional width "b". Due to
this the formation of a rectangular structure will
be easier and there is some space for the glue. Of
course we also offer the same tools at 90° tip
angle if you do not wish to have a gap.
Caution: These bits are - like all single cutting
edge tools - out of balance (except the both end
split types). If using bigger diameters make
sure that your spindle is able to stand the
out-of-balance forces. If not: For the same purpose
we offer a symmetrical (balanced) router bit FV09
with diameter
20 mm an. See "ROUTING BITS". |
|
|
|
|
Bending
procedure:
|
|
|
GIS
Gienger Industrie-Service
• Segantinistr. 5 • CH
- 8049 Zurich • Tel. /
Fax +41-(0)44-341 5028 •
mail: info@gis-tec.com
Warehouse EC • Weimarstr. 15 • D -
78532 Tuttlingen • Tel.
+49-(0)7461-162020 • Fax
162021 |
|
|
|
|